GLP JDC2 IP V2.0.1 |
|
New Features and improvements |
- Changed DigiFX and NDI settings and their manipulation overall. Therefore, please refer to the additional manuals.
- Canvas based positioning workflow and coordinate system for DigiFx and NDI.
- Added Strobe Cycle at Zero: Reset and Continuous
- Added Rate / Duration Cycle options: Restart, Finish, Smart
- Added flash style options: normal, spark.
- Added PWM settings in the control channel
- Added network port status in the main display screen.
- Added Manual DMX Added DMX Input Monitor
|
|
Bug Fixes |
- Solved an issue affecting the strobe sync
- Solved an issue in the stand alone mode
|
|
Info |
- ⚠️This update is show critical and is an important update to secure show stable preprogramming and show stable fixture updates in the future.
- All DMX Modes have been changed and all DMX channel counts are different, compared to the previous release version 0.7.1-rc7.
- DigiFX have been changed (removed, adjusted, moved in position, etc.).
- Coordinate settings have been changed and simplified, strobe options have been added.
- We strongly recommend against performing this update on-site.
- Power cycle the fixture after the update.
|
|
How to update |
Precaution / before the update
Please connect your fixtures via DMX AND Ethernet. Make sure your Ethernet adapter and fixtures are on the same network settings and check if you see the fixtures via the iQ.Service App.
You just may use the default DHCP and have your fixtures for example at 169.254.x.x/16 DHCP and your USB-C to ethernet adapter on 169.254.0.2 / 255.255.0.0 This can be set in the iOS settings on you iPhone as soon an adapter is connected. |
|
Please see and follow the provided update instructions and documentation.
The update works in 2 major steps:
- Via iQ.Service App and iQ.Tool: Bootloader update to V3.4.1, via DMX/RDM.
- Via iQ.Service App / iQ.Tool and Ethernet network daisy chained, update the main software via ethernet to V2.0.1.
- It is most likely, that an iQ.Mesh software update is suggested as well.
Please perform this after the main firmware update. For iQ.Mesh Updates please set all fixtures to iQ.Mesh. You can change the control protocol via the upper right tools menu. Depending on the production lot the iQ.Mesh update will not work on all fixtures. If the update does not work, please contact your local distributor. This update must be performed then in GLP headquarters. The regular function and work via DMX and Ethernet is not affected, only the iQ.Mesh will not work. |
|
Versions: |
- JDC-2_2.0.1_sus.bin
- Bootloader Version 3.4.1
- iQ.Service V2.7.3 or later
|
|
Download firmware & changelog: |
|
|
